It is currently Fri Oct 31, 2014 3:30 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: UNMOUNTABLE BOOT VOLUME on Vista - HELP !!!!
PostPosted: Tue Jul 22, 2014 1:56 pm 
Offline

Joined: Tue Jul 22, 2014 1:16 pm
Posts: 2
Hello everyone,

Here is the situation : I've got a DELL laptop computer, equiped with Windows Vista.

I've tried today to set up Powerquest Partition Magic 8 to set up Win7, when I finished installing the software I've got several error messages, I clicked OK then the computer has instantly shown a Blue screen of death, and rebooted.

Then, I've never made it to start it again.

When I start normaly, the blue screen (BSOD) comes again then reboot, idem with Safe mode.

I've got a recovery DELL partition, the only one I can start, where I can choose to repair, to make a full hard reset of the computer, but I need to get back some datas absolutely. I've tried to repair the boot sequence, nothing happens when I click on the button.

I've put the Windows Vista CD, boot with it, nothing happens. Doesn't work.

I've run cmd.exe and tried a chkdsk in recovery mode, it said I have to reboot the comp to start the check, then nothing happens when I do it.

The thing is when I'm in recovery mode, I'm sensed to see the OS in the window, it's wrotten "Unknown". Also, it's asking me for drivers because no OS is found.

When I browse different volumes in recovery mode, I can see DVD, USB key, I can see recovery disk, but I DONT SEE the main C: disk, it just DISAPPEARED !!!

My hypothesis is : Partition Magic isn't compatible with Windows Vista, unfortunately I haven't read that properly, then a conflict appeared and the software simply "removed" or "taken out" my main Windows Vista disk from the computer.

SO I've downloaded UBCD, burnt it on a CD, tried to run it during boot sequence, nothing happens, it takes me to Win Vista loading gauge then crashes.

I don't know what to do.... I know I can get access to cmd.exe in recovery mode, I thought about launching UBCD thru DOS.... but how do I launch it thru MSDOS ??

Thanks for your help!!!!


Top
 Profile  
 
 Post subject: Re: UNMOUNTABLE BOOT VOLUME on Vista - HELP !!!!
PostPosted: Fri Jul 25, 2014 12:24 pm 
Offline

Joined: Tue Jul 22, 2014 1:16 pm
Posts: 2
Thanks everyone for your help, that was great. Good to know there are always people ready to bring help :|

So after 3 full days of researches and different tryouts, I finaly repaired my computer all by myself.

Here is the way I made it, for those who shall have the same problem :

First off, the problem really came a partition problem.
As I said before, Partition Magic is NOT compatible with Windows Vista. So my hypothesis was right.

Impossible to restore, to repair or whatever since Windows couldn't find any OS installed, the partition had just disappeared and it was as if there was no OS installed and ready to boot on the computer.
I've tried Vista CD, even Win7 CD, even WinXP CD, none of 'em found any OS installed, so nothing to repair.
Tried all these 3 Windows OS CDs to try a new OS setup straight from boot sequence, none of them worked, error message everytime : partition damaged, no free partition to use.... tried to use the format tool, didn't work.

My solution :

- I finaly found a way to start Ultimate Boot CD (thanks very much, great f***** GREAT program !!!! but tough to master) ;
- Started PTTD to format one of my unused partitions, clear it up and make it ready to host a new OS (format it in NTFS) ;
- Started Parted Magic to use TestDisk (thanks very very much to this great software as well !!!!!!!!!), to clean all my partitions and write new Partition Table (which was screwed and cause of issues) ;
- Ran Win7 CD at boot sequence to install it on my freshly formated partition, everything went fine ;
- Ran Win7 to save all my datas on my HDD (in case something went bad afterwards) ;
- Ran cmd.exe (admin mode) and made a chkdsk /r on my Vista partition (took several hours) ;
- Rebooted computer, then booted Win7 CD to get in recovery mode (repair), initialy I wanted to make a bootrec/fixboot, but finaly I could see my 2 OS appeared properly so I clicked on the button to repair Vista's boot sequence ;
- Rebooted, IT WORKED !

Hope this helps.

Once again, thanks again for this great UBCD program that saved my computer (even if it's very difficult to use it, so many programs and we don't really know how different they are, what are the ones adapted to the current situation...) and also thanks very much to Parted Magic & TestDisk which are very complete, simple and powerful programs to use.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Protected by Anti-Spam ACP Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group