It is currently Sat Nov 25, 2017 1:48 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Mar 24, 2015 12:47 pm 
Offline

Joined: Tue Mar 24, 2015 12:41 pm
Posts: 1
I have a Lenovo T450 that I was going to image with Clonezilla but when Parted Magic booted it said no network connections. The Ethernet connection is fine because I installed all the drivers and ran sysprep before I used UBCD. I was told perhaps UBCD doesn't have the drivers for my laptop possibly (we are just guessing). I looked at customizing the UBCD but it states about network drives but doesn't walk me through how to install because I just have .eve from Lenovo that holds the drivers. I tried to go with using the freedos customizing but it never states where to place my cab file or if this is even correct. Any help would be greatly appreciated as I have run out of ideas to get Parted Magic to see the drivers.


Top
 Profile  
Reply with quote  
PostPosted: Wed Mar 25, 2015 10:00 pm 
Offline

Joined: Sat May 08, 2010 5:26 am
Posts: 825
The simpler solution for you would be to use the latest version from http://clonezilla.org instead of playing with pmagic or with UBCD.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Protected by Anti-Spam ACP Powered by phpBB® Forum Software © phpBB Group