Parted Magic No Network Connections

Try looking for help here if you are having problems with the latest beta of Ultimate Boot CD.

Moderators: Icecube, StopSpazzing

Post Reply
Posts: 1
Joined: Tue Mar 24, 2015 12:41 pm

Parted Magic No Network Connections

#1 Post by dynamictwo » Tue Mar 24, 2015 12:47 pm

I have a Lenovo T450 that I was going to image with Clonezilla but when Parted Magic booted it said no network connections. The Ethernet connection is fine because I installed all the drivers and ran sysprep before I used UBCD. I was told perhaps UBCD doesn't have the drivers for my laptop possibly (we are just guessing). I looked at customizing the UBCD but it states about network drives but doesn't walk me through how to install because I just have .eve from Lenovo that holds the drivers. I tried to go with using the freedos customizing but it never states where to place my cab file or if this is even correct. Any help would be greatly appreciated as I have run out of ideas to get Parted Magic to see the drivers.

Posts: 826
Joined: Sat May 08, 2010 5:26 am

Re: Parted Magic No Network Connections

#2 Post by ady » Wed Mar 25, 2015 10:00 pm

The simpler solution for you would be to use the latest version from instead of playing with pmagic or with UBCD.

Post Reply