Ultimate Boot CD
http://www.ultimatebootcd.com/forums/

Tools won't load - i2c detect fail error
http://www.ultimatebootcd.com/forums/viewtopic.php?f=10&t=14887
Page 1 of 1

Author:  taylornate [ Sat Jul 30, 2016 11:58 am ]
Post subject:  Tools won't load - i2c detect fail error

I installed UBCD onto a thumb drive using Rufus, and my system boots into the menu, but whenever I select a tool, I get the same error: i2c-0: detect fail: address match

Image

I've tried rebooting and loading a few other tools with the same result. This system is a Supermicro X8 series motherboard with dual E5600 series CPUs:

Image

I've tried changing the partition type in Rufus to GPT to see if that would help. No difference. I have previously run a pure memtest thumb drive with no problems.

Any help appreciated. Thanks.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/