It is currently Fri Aug 29, 2014 10:30 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Using UBCD to identify bad HDD sectors and avoid them
PostPosted: Sat Jul 10, 2010 11:08 am 
Offline

Joined: Sat Jul 10, 2010 11:02 am
Posts: 3
I have a Toshiba laptop with at least part of the hard drive in it that is bad and am trying to figure out if I can salvage at least part of the hard drive to continue using it. I had read that I could use programs on the UBCD to identify which sectors of my HDD are bad and then create a new partition to put Windows on the section that is not bad. However, I have wandered through the utilities on the UBCD and have not come across one that tells me all the bad sectors, only ones that will tell me I have a problem with the HDD. Can someone please point me in the right direction?

Thank you very much in advance.


Top
 Profile  
 
 Post subject: Re: Using UBCD to identify bad HDD sectors and avoid them
PostPosted: Sun Jul 11, 2010 6:02 pm 
Offline

Joined: Mon Feb 21, 2005 10:59 pm
Posts: 1284
My understanding is that modern harddisks will remap bad sectors automatically during normal operation:

Source: http://en.wikipedia.org/wiki/Bad_sector
Quote:
A modern hard drive comes with many spare sectors. When a sector is found to be bad by the firmware of a disk controller, the disk controller remaps the logical sector to a different physical sector. In the normal operation of a hard drive, the detection and remapping of bad sectors should take place in a manner transparent to the rest of the system.


However, automatic remapping of bad sectors only occurs during write operations. To remap all the bad sectors on the hard disk, you will need to low-level format the HDD using the manufacturer's provided utility.

If bad sectors continue to develop even after low-level formatting, it won't be safe to use anymore IMHO. Better to get a new one than to risk losing your data.


Top
 Profile  
 
 Post subject: Re: Using UBCD to identify bad HDD sectors and avoid them
PostPosted: Sun Jul 11, 2010 7:18 pm 
Offline

Joined: Sat Jul 10, 2010 11:02 am
Posts: 3
I appreciate the reply. I have tried formatting it multiple different ways over the last week and each time I receive an error message while it tried to install windows, but windows does actually install. However, within 2-3 days it will no longer boot up properly and I have to format it again. The most recent time I used the Darik's Boot and Nuke as it appeared to be the most thorough. I am pretty sure the hard drive was bad but I was hoping maybe it would only be part of it to where I could create a partition that did not include any of the bad parts and use that going forward.

As for data loss, nearly all of my data was already stored on my desktop in addition to the laptop that has the issue, so I really didn't lose anything (thankfully). Given the age of the laptop, I'll probably just get a new netbook considering they have them as low as $250 these days and I don't need anything extensive since I have my desktop.


Top
 Profile  
 
 Post subject: Re: Using UBCD to identify bad HDD sectors and avoid them
PostPosted: Fri Jul 30, 2010 7:01 pm 
Offline

Joined: Tue Sep 09, 2008 4:37 pm
Posts: 462
Location: California, USA
As victor said, you need to use the tools provided by the manufacturer to fix the drive, but even then if the drive has that many bad sectors its pointless to keep trying to fix it as its probably on its last leg anyways. So, either replace the drive for cheap, or get a new computer as you have already suggested you were going to do.

_________________
~Just StopSpazzing~

Visit the UBCD Wiki: http://wiki.ultimatebootcd.com
Please check your UBCD ISO MD5 Hash Sum; May prevent issues later on by not having an exact copy.

Currently Working on Common Issues and Repair Tips on the Wiki.


Top
 Profile  
 
 Post subject: Re: Using UBCD to identify bad HDD sectors and avoid them
PostPosted: Sat Jul 31, 2010 5:13 pm 
Offline

Joined: Sat Jul 10, 2010 11:02 am
Posts: 3
I appreciate the reply. I did end up buying a new hard drive for the laptop, and it's been running for 1 1/2 weeks w/o any problems. Part of me wanted to go get a netbook, but glad I saved the money.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Protected by Anti-Spam ACP Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group