Chipset Unknown error??
Posted: Wed May 11, 2011 2:27 pm
Ok, so I've been using the UBCD v5.0.3 with my new server. I'm looking to set it up as test box. I've installed ESXi 3.5 on the system. That install had issues and I'm looking to basically wipe the drive, start over and install ESXi to a internal USB. Previously before the install of ESXi 3.5 I used UBCD n fdisk to delete / remove the partitions before the install and have them created during install. Because although the install said it completed correctly, a few services wouldn't start thus the start over. I'm attempting to wipe the disk and in doing so, each time fdisk loads or any of the other HDD tools, it gets the following message and stops. "The chipset is unknown!" Also see image link.
Server:
HP Proliant ML110 G6
Intel Xeon
4g RAM
http://i1081.photobucket.com/albums/j34 ... /photo.jpg
Steps:
1. Inserted UBCD
2. booted up
3. hit enter to start UBCD
4. selected HDD then
5. select Boot Partition (yes not fdisk, but fdisk worked before. I've actually tried XFDISK, SPFDISK, and other all doing the same thing.)
Anyone point me in the direction for help on this or what I need to do in order to allow UBCD to run again and partion/format the disk?
thanks,
Server:
HP Proliant ML110 G6
Intel Xeon
4g RAM
http://i1081.photobucket.com/albums/j34 ... /photo.jpg
Steps:
1. Inserted UBCD
2. booted up
3. hit enter to start UBCD
4. selected HDD then
5. select Boot Partition (yes not fdisk, but fdisk worked before. I've actually tried XFDISK, SPFDISK, and other all doing the same thing.)
Anyone point me in the direction for help on this or what I need to do in order to allow UBCD to run again and partion/format the disk?
thanks,