Page 1 of 1

No ISO Image

Posted: Wed Apr 16, 2008 7:36 am
by Larry Smith
Hello everyone
Been having build problems with 4.1.1, but can't find anything searching the site for an answer.

After updating UBCD there is only a 34kb iso image, and I can't figure out why. :(

Posted: Wed Apr 16, 2008 8:18 pm
by The Piney
Need more info. Did you update defs/programs and try to rebuild the ISO? Did you run ubcd2iso.bat? If so, what exactly did you type at the prompt?

My ubcd is extracted to my D: drive so my command is:

D:\ubcd\tools\ubcd2iso\>ubcd2iso.bat d:\ubcd d:\ubcd\ubcd411.iso

Posted: Fri Apr 18, 2008 2:23 pm
by Larry Smith
The Piney wrote:Need more info. Did you update defs/programs and try to rebuild the ISO? Did you run ubcd2iso.bat? If so, what exactly did you type at the prompt?

My ubcd is extracted to my D: drive so my command is:

D:\ubcd\tools\ubcd2iso\>ubcd2iso.bat d:\ubcd d:\ubcd\ubcd411.iso
I used the updater from the RescueME Website and ran the bat file to update the virus definitions in C:\UBCD folder on my C drive. When finished, the process stops, brings up the iso burner, then leaves a 34kb iso image.

To get around the problem, I use Ultra ISO to extract the files to C:\UBCD to update them, then copy the contents back to the ISO image and save it, then burn the ISO in Nero.

This may sound odd, but it works...