Opening current filesystem using DOS in UBCD
Posted: Wed Mar 11, 2009 6:27 am
Hello, I have the DOS 6.22 IMG File in my UBCD which I put there with the custom IMG section.
It runs fine and I can use all DOS commands there except that it only executes on the A:/
I need to change a few windows system files but cannot do it since Vista uses those files during runtime. Can I copy those files to the required folder from booted UBCD tools?
I have Vista and sadly it does not come with DOS pre-installed. I just have a single System Partition, and another for recovery purposes (im using compaq). I created a 100 meg volume from the free space in the recovery drive so as to house DOS if it is required.
Can anyone give me the instructions, be it accessing the file system from Booted disc or to install DOS in the system?
The files I'm talking about is in WINDOWS/system32 and the to-be-copied files are in another folder in C:/
Thanks a lot..
It runs fine and I can use all DOS commands there except that it only executes on the A:/
I need to change a few windows system files but cannot do it since Vista uses those files during runtime. Can I copy those files to the required folder from booted UBCD tools?
I have Vista and sadly it does not come with DOS pre-installed. I just have a single System Partition, and another for recovery purposes (im using compaq). I created a 100 meg volume from the free space in the recovery drive so as to house DOS if it is required.
Can anyone give me the instructions, be it accessing the file system from Booted disc or to install DOS in the system?
The files I'm talking about is in WINDOWS/system32 and the to-be-copied files are in another folder in C:/
Thanks a lot..