Page 1 of 1
cannot format
Posted: Mon Apr 11, 2005 11:34 pm
by zoran
i cannot format my 1st partition (system is on this) from windows setup,i get a msg saying that it cannot be formatted, i can delete the partition and create it but not format it.
what are my options here, i also must tell u that i have a second partition available but in there i have all of my valuable data. how can i retreive them and then install winxp on the 1st partition?
p.s. its a laptop
This question should be answered
Posted: Wed Apr 20, 2005 9:37 am
by cocha
This is a typical scenario, i use a boot diskette and with the fdisk and format tools i create the partitions and format the drives to be ready to install any operating system.... But how to do the same task using UBCD?
Posted: Wed Apr 20, 2005 5:51 pm
by Scott Cooper
From the FAQ:
Question: Does the Ultimate Boot CD include FDISK?
Nope. I was afraid if I did that Micro$oft might send their secret police after me!
But you can use Ranish Partition Manager, which is a very nice and capable substitute for FDISK. Or you could boot the FreeDOS image, which includes the FreeDOS version of FDISK.
cannot format
Posted: Wed Apr 20, 2005 7:10 pm
by Victor Chew
You need to customize the CD and include your own disk image that does
what you want.
Last comment about it
Posted: Thu Apr 21, 2005 3:51 am
by cocha
i understand about fdisk, but UBCD does not have any "format" tool ?
cannot format
Posted: Fri Apr 22, 2005 5:36 pm
by Victor Chew
Formatting a HDD involves writing specific filesystem information to a
partition. With DOS, you could typically only format FAT16 or FAT32
filesystems. I have not heard of any freeware DOS tool that will allow
you to format NTFS filesystems, not even with NTFSDOS.
I am not the expert here, but you might have better luck with
INSERT/UBCD, since Linux had traditionally been very strong in support
various filesystem types.
Posted: Sat Apr 23, 2005 5:08 am
by Victor Chew
This information from another topic in the forum:
If you run UBCD Full, with Insert, you can run Qtparted which
is a Partition Magic clone; from there you can create/resize/
delete partitions, even NTFS.
Besides creating an NTFS partition, you can also format the NTFS partition, which is what you need.
Thanks to bldrdash, the original contributor for INSERT/UBCD for posting this tip!
Las question about it
Posted: Mon Apr 25, 2005 10:08 am
by cocha
thx for the feedback, but what about formating from UBCD a partition with FAT32 file system....
I need to solve this because i dont have a Operating System boot CD, and my computer does not have a floppy drive, so my only option is UBCD boot CD...
Posted: Mon Apr 25, 2005 7:16 pm
by Victor Chew
I believe Qtparted can handle FAT32 partitions as well...
Posted: Tue Apr 26, 2005 4:17 am
by cocha
Thx a lot for taking time to answer my question.... im gonna try that