can't interpretate errors resulting from Lucifer
Posted: Wed Jun 21, 2006 7:50 am
Hi NG.
I have a notebook with WinXP which sometimes shows the following error message:
So today I downloaded the latest version of Full UltimateBootCD and startet the Burn-In-Test Lucifer.
I ran the software for about 6hours and because I don't know how to stop the test, I pressed CTRL+C. The last result shown on the screen in the last line was Errors - 10. (I'm afraid I didn't write down each line which was shown on the screen.)
Isn't there a log file available for Lucifer?
Is there manual available for Lucifer?
Can anybody interpretate this meaningless error message?
Greetings,
Peter
[/code]
I have a notebook with WinXP which sometimes shows the following error message:
Code: Select all
*** Hardware Malfunction
Call your hardware vendor for support
*** The system has halted ***
NMI: Channel Check / IOCHK
I ran the software for about 6hours and because I don't know how to stop the test, I pressed CTRL+C. The last result shown on the screen in the last line was Errors - 10. (I'm afraid I didn't write down each line which was shown on the screen.)
Isn't there a log file available for Lucifer?
Is there manual available for Lucifer?
Can anybody interpretate this meaningless error message?
Greetings,
Peter
[/code]