UBCD on a USB flash drive

Message

scumari · #1 Post by **scumari** » Sun May 13, 2007 6:13 am

Does anybody have UBCD working on a USB flash drive?

McStarfighter · #2 Post by **McStarfighter** » Sun May 13, 2007 1:21 pm

If you have read only a little bit of the forum or the changelog, you would know that the UBCD have a script for making a UBUSB...

Metshrine · #3 Post by **Metshrine** » Sun May 13, 2007 1:23 pm

On your UBCD, use the ubcd2usb tool. The syntax is as such:

ubcd2usb PATHTOUBCDFILES PATHTOUSBDRIVE with an optional -D paramter where you can specify the DISK # as found in windows disk management. So a sample command would look like such

ubcd2usb c:\tempubcd g:\ -D 6

scumari · #4 Post by **scumari** » Mon May 14, 2007 6:17 am

If you have read only a little bit of the forum or the changelog, you would know that the UBCD have a script for making a UBUSB...

Yeah, well, tryed that but somehow the makebootfat didn't work fine on my USB stick. was hoping for more detailed info

On your UBCD, use the ubcd2usb tool. The syntax is as such:

ubcd2usb PATHTOUBCDFILES PATHTOUSBDRIVE with an optional -D paramter where you can specify the DISK # as found in windows disk management. So a sample command would look like such

ubcd2usb c:\tempubcd g:\ -D 6

Thanks Metshrine, did find that one on the forum, will try again with your info.

scumari · #5 Post by **scumari** » Mon May 14, 2007 8:32 pm

The ubcd2usb.bat in the tools directory of the 4.10 release did the trick.
It worls perfectly.

Thanx, Rick