Parted Magic No Network Connections
Posted: Tue Mar 24, 2015 12:47 pm
I have a Lenovo T450 that I was going to image with Clonezilla but when Parted Magic booted it said no network connections. The Ethernet connection is fine because I installed all the drivers and ran sysprep before I used UBCD. I was told perhaps UBCD doesn't have the drivers for my laptop possibly (we are just guessing). I looked at customizing the UBCD but it states about network drives but doesn't walk me through how to install because I just have .eve from Lenovo that holds the drivers. I tried to go with using the freedos customizing but it never states where to place my cab file or if this is even correct. Any help would be greatly appreciated as I have run out of ideas to get Parted Magic to see the drivers.