Page 1 of 1
HUTIL doesn't work
Posted: Mon May 22, 2006 3:52 pm
by neurophyre
I've burnt two images of 3.4 and in both of them HUTIL doesn't work. The image boots fine, but Q:\HUTIL is empty and so the startup process dies with "Bad command or filename - 'hutil'".
Posted: Wed May 31, 2006 12:25 pm
by neurophyre
bump.
Is there any fix for this? I need to use the utility and don't have a floppy drive.
Posted: Wed May 31, 2006 4:54 pm
by Victor Chew
Check why you don't have Q:, which is the RAM drive. Has it been mapped to some other drive letter?
The actual app is located on the CDROM, typically T:\DOSAPPS\HUTIL. The startup script (startup.bat) copies it to the RAM drive because the app needs to write some config info on launch, so it can't be run off the CDROM (which is write-only) directly.