Page 1 of 1
F prot wont see my sata hdds how do I customise ubcd to add?
Posted: Tue Apr 12, 2005 10:17 am
by wolfie
As fprot does not see any hdd's I assume it is because they are sata, same as when you install xp. I have the drivers on a floppy . But not sure how to customise ubcd to load these automatically? I have added new virus definitions np but not much use yet lol.
Posted: Tue Apr 12, 2005 10:47 am
by wolfie
Could'nt find an edit button? Just wanted to add is it to do with NTFS system? if so what settings do I need to use for XP and to make this auto?
Posted: Wed Apr 20, 2005 9:38 pm
by Scott Cooper
I can't say for sure, but if it's NTFS you may not be able to do it.
F prot wont see my sata hdds how do I customise ubcd to add?
Posted: Fri Apr 22, 2005 5:29 pm
by Victor Chew
If you need SATA drivers in order for the HDD to work under DOS, I
suggest you create your own DOS boot disk with the SATA drivers (+ CDROM
driver), and run F-Prot from the UBCD once you have boot to DOS.
You will also need to load NTFSDOS if your HDD are NTFS-based.